Pulnix TM-7EX Manual descarregar pdf (Página 49)

3 Cognex MVS-8100C Hardware

Cognex MVS-8100C Hardware Manual 49

J8 3 1-2 Cover pins 1-2 for normal use with color or

mono cameras, with HDRIVE output to

camera 1. Cover pins 2-3 to specify Genlock

mode for a color camera on port 1, with

CSYNC input from camera 1.

J9 3 1-2 Cover pins 1-2 for normal use with color or

mono cameras, with VDRIVE output to

camera 1. Covering pins 2-3 is reserved.

J13 3 1-2 J13 has the same setting options as J8,

except that it affects a color camera on port 3.

J15 3 1-2 Cover pins 1-2 for normal use with color or

mono cameras, with VDRIVE output to

camera 3. Covering pins 2-3 is reserved.

J16 3 * For MVS-8100C revisions A, B, and C, the

jumper must cover pins 2-3. For MVS-8100C

revision D, the jumper must cover pins 1-2.

The revision level is indicated by the last

character shown on the part number labels on

the MVS-8100C.

This jumper is for factory diagnostic use only.

JP1, JP2,

JP4, JP5,

JP8, JP9,

JP12, JP13

2All

covered

Jumper’s presence selects 75 Ω or absence

selects high impedance termination of the

board’s camera ports. (See Camera Port

Termination Jumpers on page 41 for more

information.)

JP3 2 Open Reserved for internal use. Do not use.

JP6 3 2-3 Selects source of the VDRIVE signal.

Covering pins 2-3 routes the VDRIVE signal

from the MVS-8100C to the camera. Covering

pins 1-2 routes the VDRIVE signal to the

MVS-8100C from an external source

connected to jack J6.

JP7 3 2-3 Same as JP6, but for the HDRIVE signal.

Jumper

Block

Number

of Pins

Factory

default Purpose

Table 20. Jumper settings for the MVS-8100C

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 55 56

Comentários a estes Manuais

Sem comentários

Pulnix TM-7EX Manual Página 49

Comentários a estes Manuais

Manuais e produtos relacionados com Câmaras de segurança Pulnix TM-7EX