Pulnix TS-9720EN Series Manual de Instalação descarregar pdf (Página 85)

Page 73

VIS CAM 300/400 Installation Manual

Appendix B: J-Panel Functional and Connector Description

6.3.3 (b) Trigger output

Description

The trigger output is balanced and the driver is a RS485 transmitter (LTC1480).

Signal levels

The signals are standard RS485 levels. The specification below is taken from Linear Technologies

datasheet for LTC1480:

TABLE 20. Signal table

Electrical interface on the J-Panel:

FIGURE 68. J-panel electrical interface

6.3.3 (c) Ethernet Interface

100 Mb Ethernet interface. The signals are routed directly to RJ45 connector X12. The cable to the

camera must be a Cat 5e or preferably a Cat 6 cable. The wire color marking on the PCB uses standard

Ethernet wire colors.

6.3.3 (d) Power output

Voltage: 24VDC from power supply connected to X6 or X7

Current: 2A fused

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 115 116

Sem comentários

Pulnix TS-9720EN Series Manual de Instalação Página 85