Pulnix TS-9720EN Series Manual de Instalação descarregar pdf (Página 37)

Page 25

VIS CAM 300/400 Installation Manual

Installing the Vehicle Imaging System

3.3.4 X8 LS RS485 Out Connector

The RS485 output from the Light Sensor to the RS485-to-Ethernet converter connector is X8. The

connections from X8 to the converter are shown in Table 6 and Figure 23

TABLE 6. X8 to converter connector

FIGURE 23. Wiring for the X8 to converter connector.

Up to four cameras can be connected to one Light Sensor using one Moxa Nport 5232 Device Server. If

more than four cameras need to be connected to the same Light Sensor please refer to “Appendix E:

Moxa N-Port 5232 Configuration” on page 93 in this Manual.

X8 Pin # Signal Description Connection to RS485-to-Ethernet converter

+24V

24V Power output

V+ power input

2 Gnd Power return V- power input

+12V

12V Power output

4Gnd

Power return

5 D0+ RS485 databus D0+ D+ Port 2

6 D0- RS485 databus D0- D- Port 2

7 D1+ RS485 databus D1+ D+ Port 1

8 D1- RS485 databus D1- D- Port 1

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 115 116

Sem comentários

Pulnix TS-9720EN Series Manual de Instalação Página 37