Pulnix TM-76 Manual de Instruções descarregar pdf (Página 21)

Page 13

Installation

TM-1020 Series Progressive Scan Shutter Cameras

2.2.7 Power Supplies and Power Cable Setup

2.2.7 (a) Power Supplies

The TM-1020 series camera requires 12V DC power that is obtained through the 12-pin connector

located on the rear panel of the camera. PULNiX recommends the following power supplies:

K25-12 110V AC/12V DC 2.1A power supply (OEM type)

K50-12 110V AC/12V DC 4.2A power supply (OEM type)

PD-12UU 100-240V AC/12V DC 1.2A universal voltage power supply,

US Plug

PD-12UUP PD-12UU with12-pin connector US plug

PD-12UE PD-12UU European plug

PD-12UEP PD-12UU with 12-pin connector European plug

For users providing power through the 12-pin connector, the PD-12P, PD-12UEP and PD-12UUP

power supplies are available with the 12-pin mating connector already attached to the leads from the

power supply. The PD-12UU and PD-12UE power supplies can be connected to the PULNiX power

cable via a terminal strip or directly.

When wiring the PD-12UU and PD-12UE power supplies directly, please note the following:

• The lead ends must be twisted together and tin-soldered for strength and electrical continuity.

• Shrink tubing or a similar insulator should be used to prevent exposed leads from touching and

shorting.

• The +12V lead is marked with a red stripe or white lettering; be sure not to reverse the leads.

• All connections must be properly insulated to prevent shorting.

2.2.7 (b) PULNiX Power Cables

If you are using PULNiX power cables such as the 12P-02S, please refer to the 12-pin connector pin-

out diagram in “12-Pin Connector (LVDS/RS-422 version)” on page 6. The cable pin-out diagram is

shown in Figure 8 below. The color-coded leads use Gray for Ground and Yellow for +12V.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 71 72

Sem comentários

Pulnix TM-76 Manual de Instruções Página 21