Pulnix TM-200 Manual de Instruções descarregar pdf (Página 20)

OPERATION

Page 12 TM-200 / TM-300 Miniature CCD Camera

3.1.7 Interfacing to Frame Grabbers

12-pin connector or BNC.

3.1.8 Sync Output and Clock Output

TTL level internal sync and buffered pixel clock output (14.31818MHz) are available from the TM-200/

TM-300 camera. The signal is an emitter follower output requiring a termination resistor at the end of

the cable. The suggested value is from 75Ω to 330Ω.

3.2 Board Layout and Adjustment

3.2.1 Processor Board

Connect Processor Board to test jig and check all functions.

Voltage Setting

AGC Adjust VR1 (AGC) so that the pot. is 2.0V.

MGC Set VR3 (MGC) at mechanical center (2.5V at pot.). Then set ext. gain pot.

(rear panel) to 3.6V at pot.

AGC MAX. Adjust VR2 (AGC MAX) to 3.±0.1V at pot.

FIGURE 7. Processor Board

3.2.2 Mother Board

External Sync Speciﬁcation

Mechanical center

AGC

AGC MAX

VR1 VR2

VR3

MGC

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Sem comentários

Pulnix TM-200 Manual de Instruções Página 20