Pulnix TM-200 Manual de Instruções descarregar pdf (Página 14)

INSTALLATION

Page 6 TM-200 / TM-300 Miniature CCD Camera

FIGURE 2.

12P-02 Interface Cable (optional)

Note:

Make sure that the unused leads are not touching and that there is no possibility that the

leads could short due to exposed wires.

2.2.2 (c) “K” Series Power Supplies

Attach the 110V line cord to the two terminals marked “AC”. Do not plug the cord into a 110V AC

socket until later in the procedure. Next, attach the Grey and Yellow leads of the power cable to the

Ground and 12V DC terminals respectively. Be sure to replace the plastic terminal guard on the power

supply at this time.

Note:

The “K” series power supplies are designed primarily for OEM users who will be

mounting the power supply inside a protective enclosure. For use in exposed situations,

the DC-12N and PD-12 are recommended.

2.2.2 (d) Building Your Own Power Cable

Consult the pin-out for the camera purchased. Connect the Ground and +12V power leads of the PC-

12P power connector to Pin #1 and Pin #2, respectively (power must be DC regulated, and of sufﬁcient

current to properly power the camera).

2.2.2 (e) Attaching the Power Cable to the Connector

The 12-pin connector is keyed and will only ﬁt in one orientation. Rotate the connector while applying

slight pressure until the keyways line up. Press the connector into place until ﬁrmly seated.

The power cord may now be plugged into the 100V AC socket, and the camera powered up.

12P-02 Interface Cable

Pin# Lead Color Function Pin# Lead Color Function

1 Gray GND 7 Black coax VD Input

2 Yellow +12VCD 8 White coax shield GND

3 Red coax shield GND 9 White coax HD Input

4 Red coax Video 10 Brown N/C

5 Orange coax shield GND 11 Blue Integration

6 Orange coax N/C 12 Black coax shield N/C

32mm

2,000mm± 10mm

(2 Meters)

PC-12P (Hirose Part #10A-10P-12S/PC12P)

Flying

Leads

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Sem comentários

Pulnix TM-200 Manual de Instruções Página 14