Pulnix TM-1300 Manual de Instruções descarregar pdf (Página 13)

Page 5

Installation

TM-4000CL Series Progressive Scan Shutter Cameras

• Mount the camera on a large heat sink (camera bracket) made out of heat-conductive material like

aluminum.

• Make sure the flow of heat from the camera case to the bracket is not blocked by a non-conductive

material like plastic.

• Make sure the camera has enough open space around it to facilitate the free flow of air.

Please contact JAI PULNiX, Inc. at (800) 445-5444 or send an E-mail to imaging@jaipulnix.com if you

have any questions.

2.2.2 Connector Pin Configurations

2.2.2 (a) 12-Pin Connector

The TM-4000CL has a 12-pin Hirose connector for power input and signal integration. Pin #1 is

Ground and pin #12 is +12V DC. The pin-out table is shown below. Serial communication camera

control is done via the Camera Link connector on the rear panel of the camera.

TABLE 1. 12-Pin Connector

2.2.2 (b) Digital I/O Connector

The TM-4000 has a 26-pin connector on the rear panel to output Camera Link data. The connector pin-

out is shown in Table 2 on page 5.

TABLE 2. Connector and Pin-out Configurations

Pin Description Pin Description

1GND 7

NC/VD in

2 +12V DC 8 Strobe

3 GND (analog) 9

NC/HD in

4 Video out 10

NC/RXD (RS-232)

*. Option

5 GND (digital) 11

NC/Integration Control

NC/VINIT in

NC/TXD (RS-232)

Camera Link Connector

Pin # Description I/O Pin # Description I/O

1 GND 14 GND

2 Tx OUT 0- Out 15 Tx OUT 0+ Out

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Sem comentários

Pulnix TM-1300 Manual de Instruções Página 13