Pulnix TMC-6700 Series Manual do Utilizador descarregar pdf (Página 74)

Kamerakabel

_______________________________________________________________________________________________________

INSPECTA hardware manual Rev 1.86 page 74

0x934 16 1-plane

6.62 Pulnix TMC-74/76/6/7 RGB camera without pixel clock

(Part # KKRH**TMC-7X)

for PULNIX TMC-74, TMC-76, TMC-6, TMC-7

camera modes for TMC-74/7 (NTSC) color cameras without pixel clock:

mode hex bpp clock Mhz sync il shu hfreq Khz

0x148 24 14.1875 cs/sep Y N ext

0x188 16p 14.1875 cs/sep Y N ext

0x1E8 32p 14.1875 cs/sep Y N ext

camera modes for TMC-76/6 CCIR color cameras without pixel clock:

mode hex bpp clock Mhz sync il shu hfreq Khz

0x368 24 14.1875 cs/sep Y N ext

0x378 16p 14.1875 cs/sep Y N ext

0x388 32p 14.1875 cs/sep Y N ext

camera modes for TMC-76/6 CCIR color cameras with pixel clock:

mode hex bpp clock Mhz sync il shu hfreq Khz

0x078 24 ext cs/sep Y N ext

0x178 16p ext cs/sep Y N ext

0x1A8 32p ext cs/sep Y N ext

6.63 PULNIX TMC-9700 analog with RS-232

(Part # KKRH**C9700)

for PULNIX TMC-9700 (CAMC9700)

TMC-9700 is connected to the Inspecta via one cable. There are three connectors

on the camera side, the D-Sub 9-P male, the Hirose 12-P and the Hirose 6-P

connector.

The cable is split on the Inspecta side for an additional connection to one of

the serial connectors (9-pin D-Sub female). This cable is app. 20cm long

6.64 Schaefter + Kirchhoff digital linescan

(Part # KKRDSK08B**)

for Shaefter & Kirchhoff SK5000 DJR, SK7500 DJR

and others

NOTE: S&K digital Cameras must be modified for MIKROTRON!

All signals marked with +/- are twisted pairs.

Remark 1: Power supply wires (same AWG as signal wires) are split at the D62P-

HD connector with open end (app. 20 cm long)

camera mode bpp

0x49A 8

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 122 123

Sem comentários

Pulnix TMC-6700 Series Manual do Utilizador Página 74