Pulnix TMC-6700 Series Manual de Instruções descarregar pdf (Página 31)

Page 23

TMC-6700/1000 Series RS-232C Control

TMC-6700/1000 Series Progressive Scan CCD Digital Color Camera

4.2 Basic Command Code

4.2.1 Set/Refresh RAM Bank

Function: Set or refresh the RAM bank.

Four user’s RAM banks are available from Bank 1 to Bank 4. Typical situations in

which you may want to use this command are when you want to change to another

RAM bank, and when you want to reflect changes after sending the shutter command,

WB command, etc.

TX Command Code

MSB LSB

76543210

1010D3D2D1D0

D3 0 : Override Rear Panel Flag Off

1 : Override Rear Panel Flag On

D2:0 Ram Bank Number -1 (0, 1, 2 or 3) Ex: Bank 1: 00

If the “Override Rear Panel” flag is on, the rear panel settings are overwritten by the

software settings. If the flag is off, the rear panel settings reflect on the image.

Note: The rear panel setting gets priority. Once you change any rear panel setting on the back of

the camera, the parameters reflect the new rear panel setting.

Example: Set RAM bank 1 with override panel flag on. The command code packet is sent as

follows:

10101000 (BIN) or 168 (DEC)

4.2.2 Get RAM Bank

Function: Get the number of the RAM bank currently being used.

The current RAM bank number is returned from the camera in response to the

following command code:

TX Command Code

MSB LSB

76543210

1110XXXX

Bits 3 to 0 are no-care bits. The camera responds as the following 8-bit binary data:

RX Response Code

MSB LSB

76543210

0000D3D2D1D0

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 47 48

Sem comentários

Pulnix TMC-6700 Series Manual de Instruções Página 31